System Configuration and Setup 2-5
!
Continue to hold the battery release latch as you slide the battery out of the system.
Removing the battery
A
– Battery Release Latch
4.
Insert the new battery as follows:
!
Locate the alignment groove on the edge of the battery.
!
Locate the alignment groove inside the battery bay.
!
Align the grooves on the battery with the grooves in the bay.
!
Slide the battery into the bay until securely locked into place.
Installing the battery
5.
Turn over the system.
Charging the Battery
When the system is on or off or in Suspend mode and the AC adapter is connected, charge time
is approximately 3 hours.
For maximum battery performance, fully discharge the battery before recharging it. To do so,
unplug the AC adapter, turn off power management features (through BIOS Setup and Windows
power management), and turn on the system. Once the battery is fully discharged, plug in the
AC adapter and recharge the battery.
To Next Page
Loading...
