Disassembly and Reassembly 3-19
Diskette Drive
Use the following steps to remove the diskette drive.
1.
Remove the LCD panel, keyboard, heat plate, top cover, audio board, and I/O board from
the system.
2.
Locate and remove the two screws securing the diskette drive to the base assembly.
Removing the diskette drive screws
A
– Screws
B
– Diskette Drive
3.
Lift the diskette drive out of the base assembly. Slightly tilt the drive front side down to
slide the drive release button out of the base assembly.
To Next Page
Loading...
