NEC VXI Series - Switch Settings

3-4 Disassembly and Reassembly
4.
Locate the memory module slot.
5.
To remove a SO-DIMM, press the locking tabs away from the sides of the module until the
module pops up. Then, remove the SO-DIMM.
Removing the memory module
Switch Settings
A six-position dip switch is located on the bottom of the system. The switch is accessible by
removing the access panel beneath the CD-ROM drive. The following list identifies each switch
setting and its function.
!
Switch 1, Password override — The default setting is “OFF.” If you forget your password
and cannot access the data on your NEC Versa, change the setting to “ON” and your current
password is erased.
!
Switch 2 — Keyboard select; Default is “ON” for U.S. 85 key keyboard.
!
Switch 3 — Reserved for factory use; Default is “ON.”
!
Switch 4 — Keyboard select; Default is “ON” for U.S. 85 key keyboard.
!
Switch 5 — Password enable; Default is “OFF” (enabled).
!
Switch 6 — Logo select; Default is “OFF” for U.S.
Default switch settings