2-22
System Configuration and Setup
Installing the Software
The Application and Driver CD dialog box consists of the following components.
!
Selection Tabs — Located just below the title bar, each tab represents a software category.
The selection tabs include applications, drivers, utilities, Internet browsers, and the NEC
Online Documentation.
!
Description — Located in the bottom portion of the dialog box, the text describes the
selected or highlighted software category or application, driver, etc.
!
Install — Clicking the Install button installs the selected software.
!
Exit — Clicking the Exit button closes the Application and Driver CD dialog box.
Once the Application and Driver CD dialog box appears, follow these steps to install the desired
software.
1.
Click the selection tab of your choice.
2.
Click the desired application, driver, or utility.
3.
Click the Install button to install your selection.
Follow the on-screen instructions to install your selection.
4.
Click Exit to close the Application and Driver CD dialog box.
5.
Remove the CD from the CD-ROM drive when the installation is complete.
To Next Page
Loading...
