System Configuration and Setup 2-15
— Off — disables power management and all device timeouts. Works well in an office
environment while powering your NEC Versa with AC power.
— Custom — lets you define power management levels and specific device timeouts
according to your own needs and present environment. Custom lets you set the
following timeouts.
Custom Timeout Options
Option Definition
CPU Speed Control Sets CPU performance at one of four levels.
Hard Disk Timeout Sets the time delay before your hard disk powers
down.
Video Timeout Sets whether to timeout the video or not.
Peripheral Timeout Sets whether to timeout the peripheral or not.
Audio Device
Timeout
Sets the time delay before your audio device powers
off.
Standby Timeout Selects the system standby timeout period.
Auto Suspend
Timeout
Defines how much time elapses before the Suspend
Option occurs (Suspend or Save to File).
!
LCD Suspend — Allows you to suspend the system when the LCD panel is closed.
!
Suspend Option — Specifies either Suspend or Save to File (STF) as the default power
management mode.
!
Automatic STF — Enables the system, after 30 minutes in Suspend mode, to save the
current working environment to a special file on the hard disk and to power down the
system.
If Auto Save to File is set to Off and the save-to-file area is present on your hard drive,
pressing the
Fn-Power/Sleep
key combination puts the system into Save to File mode.
!
Panel Brightness — Selects the LCD screen brightness.
!
Suspend Warning Tone — Specifies whether the system warning tone sounds when
Suspend mode starts. It is best to keep this option enabled.
!
Remote Power On — Allows the modem or LAN to wake the system.
!
Wake Up from Suspend Alarm/Resume Alarm Time — Allows the alarm to wake up the
system from Suspend. Designates the time parameter in five minutes increments.(Not
applicable in Windows 98/2000 with ACPI.)
!
Intel SpeedStep Technology — Optimizes CPU performance when the system is powered
under AC or by battery.
To Next Page
Loading...
