Needit ProTeam PARK MINI 2 - Installation and Usage Guidance; Fitting the PARK MINI 2 to Windscreen

46
correct seng of the parking disc is always the responsibility of
the driver of the vehicle.
Needit ApS and importer will not reimburse any parking
charges.
Fing the PARK MINI 2
1. Find a suitable spot on the inside of the windscreen
where all 4 adhesive pads are in contact with the glass.
When you do so, make sure that all the buons on
the back of the clock are accessible and you can easily
change the baery. We recommend placing the disc in
the lower right corner in the passenger side.
2. Clean the inside of the windscreen in the area you have
planned for the parking disc with glass cleaner or damp
cloth. Wipe the glass dry carefully. You may use mark-
ing tape on the outside of the windscreen to help
nding the best locaon for the device.
3. Make sure that the screen is at least +15 °C, as the ad-
hesive pads do not work correctly at lower tempera-
tures. If necessary, warm up the windscreen using the
vehicle’s fan or (very carefully) with a hair-dryer.
4. Remove the protecve lm from the adhesive pads and
press the parking disc rmly against the windscreen for
about 30 seconds. Do not press against the middle of
the back. Then check from the outside that both adhe-