Operating the appliance en
15
6. Set the specified type of heating, temperature and
steam assistance, then start the appliance.
~ "VarioSteam – Steam-assisted cooking"
on page 16
7. Keep the kitchen ventilated while the appliance is
heating.
8. Use the # touch button to switch off the appliance
once the specified time has elapsed.
9. Wait for the cooking compartment to cool down.
10. Clean the smooth surfaces with soapy water and a
dish cloth.
11. Empty the water tank and dry the cooking
compartment. ~ "After every steam operation"
on page 19
Cleaning the accessories
Clean the accessories thoroughly using soapy water
and a dish cloth or soft brush.
1Operating the appliance
Oper at i ng the appl i ance
You have already learnt about the controls and how
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.
Switching the appliance on and off
To switch the appliance on or off, touch the # touch
button.
After the appliance has switched off, the display shows
whether the residual heat in the cooking compartment
is high or low.
Notes
■ Certain indicators and instructions (e.g. about
residual heat in the cooking compartment) remain
visible on the display even when the appliance is
switched off.
■ After the appliance has completed an operation, you
will hear the cooling fan continuing to run until the
cooking compartment is cooled as much as
possible.
■ Switch off your appliance when you do not need to
use it. If no settings are made for a long time, the
appliance switches off automatically.
Setting and starting the appliance operation
Example: ‚ CircoTherm hot air at 170 °C
1. Touch the # touch button to switch on the
appliance.
You go directly to the ¢ Types of heating menu.
2. Swipe to the left or right to select the type of heating.
3. Touch the bottom line.
4. Swipe to the left or right to select the temperature.
5. Touch the # touch button to start the appliance
operation.
The heat-up indicator bar and the run time appear in
the display.
Note: If you want to go directly to the 0 main menu
when you switch on the appliance, you can find
instructions on how to do this in the Basic settings
chapter under "Operation after switching on".
Default values
The appliance suggests a temperature or setting for
each type of heating. You can accept this value or
change it in the appropriate area.
Heating bar
As soon as a type of heating has started, the heating
bar appears on the display.The heating bar shows the
temperature increase in the cooking compartment.
Run time
When a type of heating has been started, the run time is
displayed. The run time counts upwards during the
operation. You can therefore check how long the
operation has already been running.
Displaying the current temperature
To show the current temperature on the display, press
the ! touch button.
The current temperature is shown briefly only when
heating up.
Further information
If the ! touch button lights up, information can be
displayed. Touch the ! touch button to do this. The
information is displayed for a few seconds.
Settings
Type of heating
CircoTherm hot air ‚ with steam
assistance Ž (high)
Temperature Maximum
Cooking time 1 hour
Display Temperature
Residual heat high above 120 °C
Residual heat low between 60 °C und 120 °C
&
&LUFR7KHUP
&
&
&
&
&
&LUFR7KHUP
To Next Page
Loading...
Need help?
General
