en Cleaning functions
18
1.
Use the function selector to set the cleaning
functions .
a The symbol and the cleaning functions appear in
the display. The first cleaning function is highlighted.
2.
Press the or button repeatedly until the symbol
is highlighted.
a appears in the display.
3.
Use the temperature selector to set the cleaning set-
ting.
Cleaning set-
ting
Cleaning
level
Duration in hours
1 Low Approx. 1:15
2 Medium Approx. 1:30
3 High Approx. 2:00
Select a higher cleaning setting if the cooking com-
partment is particularly dirty or has not been
cleaned for a while.
The duration cannot be changed.
a After a few seconds, the cleaning function starts and
the duration counts down.
a For your safety, the appliance door locks once a
certain temperature is reached in the cooking com-
partment. appears on the display.
a When the cleaning function ends, a signal tone
sounds and the duration is at zero on the display.
4.
Switch off the appliance.
When the appliance has cooled down sufficiently,
the appliance door is unlocked and goes out.
5.
Prepare the appliance for use. →Page18
Setting the cleaning function for the top oven
Ventilate the kitchen while the cleaning function is run-
ning.
WARNING‒Risk of harm to health!
The cleaning function heats up the cooking compart-
ment to a very high temperature so that food left over
from roasting, grilling and baking will burn off. This pro-
cess releases vapours, which can irritate mucous mem-
branes.
▶ Keep the kitchen well ventilated while the cleaning
function is running.
▶ Do not remain in the room for long periods.
▶ Keep children and pets away.
WARNING‒Risk of burns!
The cooking compartment gets very hot when the
cleaning function is in progress.
▶ Never open the appliance door.
▶ Allow the appliance to cool down.
▶ Keep children at a safe distance.
The outside of the appliance gets very hot when the
cleaning function is in progress.
▶ Never touch the appliance door.
▶ Allow the appliance to cool down.
▶ Keep children at a safe distance.
Note:The oven light does not come on during the
cleaning function.
Requirements
¡ Prepare the appliance for the cleaning function.
→Page17
¡ Switch off the main oven during the cleaning func-
tion.
1.
Use the function selector to set Pyrolytic self-
cleaning .
a appears in the display.
2.
Use the temperature selector to set the cleaning set-
ting.
Cleaning set-
ting
Cleaning
level
Duration in hours
1 Lightly soiled Approx. 1:15
2 Medium Approx. 1:30
3 High Approx. 2:00
Select a higher cleaning setting for very heavy or
older soiling.
The duration cannot be changed.
a The cleaning function starts after a few seconds and
the time counts down.
a For safety reasons, the appliance door locks auto-
matically once a certain temperature is reached in
the cooking compartment. appears in the display.
a Once the cleaning function has ended, an audible
signal sounds and the display shows the duration
as zero.
3.
Switch off the appliance.
Once the appliance has cooled down sufficiently,
the appliance door unlocks and goes out.
4.
Prepare the appliance for use. →Page18
Preparing the appliance for use following the
cleaning function
1.
Allow the appliance to cool down.
2.
Wipe off any ash that has been left behind in the
cooking compartment and around the appliance
door with a damp cloth.
3.
Remove white residues with lemon juice.
Note:White residues on the enamel surfaces may
be caused by heavy soiling. These food residues
are harmless. The deposits do not compromise the
functionality of the appliance.
4.
Attach the shelf supports.
→"Shelf supports", Page19
14.2 Cleaning aid EasyClean
Use the cleaning aid EasyClean for intermediate clean-
ing of the cooking compartment. The cleaning aid
EasyClean softens dirt by vaporising the soapy water.
The dirt can then be removed more easily.
Setting the cleaning aid EasyClean
WARNING‒Risk of scalding!
If there is water in the cooking compartment when it is
hot, this may create hot steam.
▶ Never pour water into the cooking compartment
when the cooking compartment is hot.
Notes
¡ The interior lighting remains off while the cleaning
aid is running.
¡ You cannot delay the end time.
¡ The length of time has been preset and cannot be
changed.
To Next Page
Loading...
Need help?
General