Nelson ALPHA 850 - Table of Contents

Table of Contents
Stud welding unit operating manual Date: July 2021
ALPHA 850 07.2021 / EN Rev.: A
TABLE OF CONTENTS
Chapter
Page
1 Introduction ............................................................................................. 1
1.1 General remarks ............................................................................ 1
1.2 Device description ........................................................................ 2
1.3 Weld process ................................................................................. 3
1.4 Process ........................................................................................... 4
1.5 Weld elements ............................................................................... 5
1.6 Ceramic rings ................................................................................ 5
1.7 Material combinations .................................................................. 6
1.8 Technical data ............................................................................... 7
1.9 Declaration of Conformity .......................................................... 11
2 Work safety ........................................................................................... 12
2.1 Safety symbols ............................................................................ 12
2.2 Safety instructions ...................................................................... 13
2.3 Intended use ................................................................................ 17
2.4 Warranty and liability .................................................................. 18
2.5 Copyright ...................................................................................... 18
3 Delivery and transport ......................................................................... 19
3.1 Scope of delivery ........................................................................ 19
3.2 Packaging and dispatch ............................................................. 19
3.3 Incoming inspection ................................................................... 19
3.4 Interim storage ............................................................................ 19
3.5 Transport ...................................................................................... 19