34
Version: 9a
13.11.2018
EN
Problem Reason Solution
1. The start light or display does not
light when power is on
No power in stove or in the
control panel.
Check the power and wires.
Fuse is broken Replace the fuse
2. The blower doesn’t work after
pressing the start bottom.
If after stabilization, it doesn’t work,
there must be something wrong
It is normal.
It will start automatically
when the temperature is
above 30 degrees on the
venting pipe.
Please wait
No power in stove or in the
control panel.
Or unplugged on the mother
board
The low temperature sensor
is broken
Check the power and wires.
Plug in
Replace it
The general troubles, the possible reasons and the solutions are as following.
After solving problems start the stove again:
To Next Page
Loading...
