NEOPAC 08 - Digital Controller Operation; ON;OFF and Working Modes; Temperature Setting (Heating and Cooling)

NeoPAC
- 42 -
Regulation (digital controller)
ON / OFF
Button starts or stops the machine. (Attention! When the machine is being turned ON
or OFF, it may take up to a few minutes to activate or deactivate.)
Working modes
Button is to choose the heat pump working mode.
To choose the working mode, press this button till the corresponding LED on the display is
lighting up.
• Auto : Automatic heating and cooling mode.
Maintains the temperature of the water between heating temperature setting and cooling
temperature setting (+ or – 2°C).
• : Water heating mode.
Maintains the water temperature at the heating temperature setting (+ or – 2°C).
• : Water cooling mode
Maintains the water temperature at the cooling temperature setting (+ or – 2°C).
Water heating setting
• Turn the machine into heating mode (see « working modes »).
• Press , the heating setting value is shown.
• Set the value with and . It saves automatically after a few seconds.
Water cooling setting
• Turn the machine into cooling mode (see « working modes »).
• Press , the cooling setting value is shown.
• Set the value with
and . It saves automatically after a few seconds.