29
ENGLISH
On this screen:
• Select or to enter the position of the first
reading mark on the sheet, measured from the
top.
• Select to enter the maximum number of
sheets in the set of documents.
• Select to confirm the changed settings, or
press the escape button to return to the
previous screen without changing the settings.
Note
When the maximum number of sheets exceeds the programmed maximum number of
sheets in a set, the machine stops and error VT:134 will be displayed. After removing the
set and pressing the RESET button, the machine will start and repeat the process until an
insert or divert mark is encountered, error VT:135 (final set part) will be displayed.
Double Feed Control (DFC) settings
This screen allows you to set the Double Feed
Control (DFC) settings for the different feeders to
ON or OFF.
From the Job Settings screen, select and then
“Edit”. The DFC Settings screen will appear.
• Select “Feeder” to select the required feeder
(select feeder 1, 2, or 3). The number of the
selected feeder will be displayed.
• Select “ON” or “OFF” to switch the DFC control ON
or OFF.
The radio button next to the feeder shows if the DFC control is ON or OFF.
ON - , or OFF - .
Select to confirm the changed settings, or press the escape button to return to
the previous screen without changing the settings.
ESC
ESC
To Next Page
Loading...
Need help?
General
