Activating and Reading the E-Coder)R900i
E-Coder)R900i Installation and Maintenance Guide 9
How to Tell if Water is in Use
To determine if water is in use, complete the following steps:
1 Check the flow indicator by closely watching it for
two minutes.
2 Determine the following conditions:
• If the arrow is flashing, then water is running very slowly.
• If the arrow is continuously ON, water is running.
• If the arrow does not flash, water is not running.
What to Do if There is a Leak
The following checklist can be helpful if the E-Coder)R900i leak
indicator shows a possible leak.
If Continuous Leak is Repaired
If a continuous leak is found and repaired, complete the following steps:
1 Use no water for at least 15 minutes.
2 Check the leak icon.
If the leak indicator is continuous ON to flashing, then a leak is no
longer indicated.
If Intermittent Leak is Repaired
If an intermittent leak is found and repaired, complete the following
steps:
Check the leak icon after at least 24 hours.
If the leak has been correctly repaired, the leak icon changes from
flashing to OFF.
Software
A software update is required for N_SIGHT™ R900 to interpret the
advanced feature data communicated from the Neptune E-Coder)R900i.
Table 4 Checklist for Leaks
Check all faucets for possible leaks.
Check all toilets and toilet valves.
Check the ice maker and water dispenser.
Check the yard and surrounding grounds for a wet
spot or indication of a leaking pipe.
To Next Page
Loading...