E-Coder)R900i Installation and Maintenance Guide 23
8 Maintenance and Troubleshooting
This section takes you through maintenance and troubleshooting procedures for the
E-Coder)R900i. The first topic will guide you through the steps necessary to replace
the battery that is in the main housing.
In addition, this section will guide you through some troubleshooting procedures for
both a six-wheel and a four-wheel encoder.
Replacing the MIU Battery (E-Coder)R900i Inside Version)
Removing the Battery Assembly:
1 Remove the tamper nail by using a small flat-blade screwdriver
and hammer. The blade of the screwdriver needs to be 1/8” to 3/
16” wide.
2 Place the end of the screwdriver in the center of the tamper nail
as shown in Figure 17.
Figure 17 Screwdriver in Tamper Nail
All data logging information will be lost once the battery is removed.
To Next Page
Loading...