Data Logging Extraction Steps
20 E-Coder)R900i Installation and Maintenance Guide
Once the initialization has taken place the data logging extraction screen
appears.
3 Select Start to begin listening for transmissions. (See Figure 10).
Figure 10 Start Button
The HHU is now ready to receive the data logging information and
displays Listening for Transmissions. (See Figure 11)
Figure 11 Listening for Transmissions
4 Activate the E-Coder)R900i register by holding the special LED
flashlight activator over the photo-sensor eye which is under the
recessed hole in the dial face (noted by the flashlight symbol) until
the LED flashes and turns off. (See Figure 17).
Figure 12 Data Logging Activation for
E-Coder)R900i Inside
You can position the activator one to two inches from the photo sensor, or
even angled slightly, and still activate the unit. Attempt to line up the center of
the flashlight and the photo sensor as closely as possible.
To Next Page
Loading...