Neptune E-CODER Quick Install Guide

14
13 If Continuous Leak is Repaired
If a continuous leak is found and repaired, complete the following
steps.
1 Use no water for at least 15 minutes.
2 Check the leak icon.
If the leak indicator changes from Continuously ON to
Flashing, then a continuous leak is no longer indicated.
14 If Intermittent Leak is Repaired
If an intermittent leak is found and repaired, complete the
following steps.
1 Check the leak icon after at least 24 hours.
If the leak has been correctly repaired, the leak icon
changes from Flashing to OFF.
2 Refer to the following tables which describe the standard
functions of the E-CODER flags.
Table 6 E-CODER Flags
Backflow Flag (Resets After 35 Days)
Based on reverse movement of the eighth digit, the eighth
digit is variable based on the meter size.
No backflow event Eighth digit reversed less than one digit
Minor backflow
event
Eighth digit reversed more than one
digit up to 100 times the eighth digit
Major backflow
event
Eighth digit reversed greater than 100
times the eighth digit
Leak Status Flag (Resets After 35 Days)
Based on total amount of 15-minute periods recorded in the
previous 24-hour period.
Leak icon off Eighth digit incremented less than 50 of
the 96 15-minute intervals

Neptune E-CODER Specifications

General

Output	Digital
Power Source	Battery or external power
Operating Temperature	-20°C to 60°C (-4°F to 140°F)
Power Supply	3.6V Lithium Battery
Dimensions	Varies depending on model
Weight	Varies depending on model