Neptune E-CODER Quick Install Guide

13
11 How to Tell if Water is in Use
To determine if water is in use, complete the following steps.
1 Check the flow indicator by watching for two
minutes.
2 Determine which of the following conditions exists.
• If the arrow is Flashing, then water is running very
slowly.
• If the arrow is Continuously ON, water is running.
• If the arrow is not Flashing, water is not running.
12 What to Do if There is a Leak
The following checklist can be helpful if the E-CODER leak
indicator shows a possible leak.
Water-cooled air conditioner
or heat pump
Filling a swimming pool
Any continuous use of water
for 24 hours
Table 5 Checklist for Leaks
Check all faucets for possible leaks.
Check all toilets and toilet valves.
Check the ice maker and water dispenser.
Check the yard and surrounding grounds for a wet
spot or indication of a pipe leaking.
Table 4 Possible Leaks
Possible Cause of Leak
Intermittent
Leak
Continuous
Leak

Neptune E-CODER Specifications

General

Output	Digital
Power Source	Battery or external power
Operating Temperature	-20°C to 60°C (-4°F to 140°F)
Power Supply	3.6V Lithium Battery
Dimensions	Varies depending on model
Weight	Varies depending on model