Nescafe Tama - Adjusting Personal Taste; Customizing Beverage Volume; Resetting Beverage Presets

11 of 2610 of 26 11 of 26
INDIVIDUAL ADJUSTMENTS TO YOUR PERSONAL TASTE
 
When the selected menu icon starts
flashing green you can adjust the
amount of hot water.
10
3
The power button light changes to
orange. The selected menu icon lights
green. Coee extraction starts.
Put a cup in place. Touch and hold the
menu icon for the beverage you wish
to adjust for 5 seconds.
+/−
When the beverage reaches the
desired amount touch the menu icon
to stop. If you do not touch machine
will stop at the maximum water
level!
10
4
10
1
10
2
5 sec
10
i
Resetting initial beverage recipes
① Connect the power plug.
② Check that the power is OFF.
③ Touch and hold the Cappuccino
icon THEN the power button
simultaneously.
④ Release the icons when all the
icon lights start flashing fast in
green.
⑤ Machine is now back to factory
settings.
⑥ Initial rinsing must be performed
(see page 6).
• After changing the setting, the new
setting remains the same until you
modify it again (even if the machine is
unplugged).
• When a small cup is used, the
coee may overflow the cup if you
set the amount of hot water too high.
• To adjust to a new amount of
hot water, repeat the above
procedure (the current setting
will be overwritten).
Note: For Latte Macchiato &
Cappuccino, cup parameter
can not be adjusted manually.
To adjust volume, please follow procedure below:
You can adjust the strength of the coee by changing the amount of hot water:
Espresso
type coee
Latte
Macchiato
Cappuccino
Lungo
type coee
Americano
type coee
Minimum Standard Maximum
~40 ml
~70 ml
~100 ml
~60 ml
~140 ml
~200 ml
~120 ml
~210 ml
~300 ml