netAlly LINKRUNNER G2 - Page 77

MAC Address: LinkRunner G2's MAC address
Packet Type: Touch the down caret to select
the packet type filter setting. The MAC + NetAlly
setting tells LR G2 to reflect only packets with a des-
tination MAC address that matches the LR G2's
own MAC address and NetAlly payload.
Swap: Touch the down caret to select a swap
setting. MAC + IP tells the LR G2 to swap the
source and destination MAC and IP addresses for
packets that are reflected back to LR G2.
NOTE: The recommended settings are Packet
Type: MAC + NetAlly and Swap: MAC + IP. Other
Reflector settings may cause undesired traffic on
your network.
77
LinkRunner G2 Tools