5. Select option 1 from the boot menu to continue booting into ONTAP.
********************************************************************
***************
* Select option "(1) Normal Boot." to complete the recovery process.
*
********************************************************************
***************
(1) Normal Boot.
(2) Boot without /etc/rc.
(3) Change password.
(4) Clean configuration and initialize all disks.
(5) Maintenance mode boot.
(6) Update flash from backup config.
(7) Install new software first.
(8) Reboot node.
(9) Configure Advanced Drive Partitioning.
(10) Set Onboard Key Manager recovery secrets.
(11) Configure node for external key management.
Selection (1-11)? 1
Complete the boot media replacement
Complete the boot media replacement process after the normal boot by completing final checks and giving
back storage.
1. Check the console output:
If the console
displays…
Then…
The login prompt Go to Step 6.
Waiting for giveback… a. Log into the partner controller.
b. Confirm the target controller is ready for giveback with the storage failover
show command.
2. Move the console cable to the partner controller and give back the target controller storage using the
storage failover giveback -fromnode local -only-cfo-aggregates true command.
◦ If the command fails because of a failed disk, physically disengage the failed disk, but leave the disk in
the slot until a replacement is received.
◦ If the command fails because the partner is "not ready", wait 5 minutes for the HA subsystem to
synchronize between the partners.
18
To Next Page
Loading...
