E2800 controller P1 Management Port
E5700 controller P1 Management Port
2. Open a browser and connect to the storage system using one of the controller IP addresses provided to
you by your network administrator.
Option 2: Static IP address
Learn how to configure the management ports manually by entering the IP address and the subnet mask.
Before you begin
• Obtain the controllers' IP address, subnet mask, gateway address, and DNS and NTP server information
from your network administrator.
• Make sure the laptop you are using is not receiving network configuration from a DHCP server.
Steps
1. Using an Ethernet cable, connect controller A’s management port to the Ethernet port on a laptop.
Ethernet cables (if ordered)
The following figures show examples of the controller’s management port location:
11
To Next Page
Loading...
