Step 6: Return the failed part to NetApp
Return the failed part to NetApp, as described in the RMA instructions shipped with the
kit. See the
Part Return & Replacements page for further information.
FAS8200 System Documentation
Install and setup
Cluster configuration worksheet - FAS8200
You can use the
Cluster Configuration Worksheet to gather and record your site-specific IP addresses and
other information required when configuring an ONTAP cluster.
Start here: Choose your installation and setup experience
For most configurations, you can choose from different content formats.
• Quick steps
A printable PDF of step-by-step instructions with live links to additional content.
•
Video steps
Video step-by-step instructions.
For MetroCluster configurations, see either:
• Install MetroCluster IP configuration
• Install MetroCluster Fabric-Attached configuration
Installation and setup PDF poster - FAS8200
You can use the PDF poster to install and set up your new system. The
AFF FAS8200 Installation and Setup
Instructions
provides step-by-step instructions with live links to additional content.
Installation and setup video - FAS8200
The following video shows end-to-end software configuration for systems running ONTAP 9.2.
AFF FAS8200 Setup Video
Maintain
Boot media
Overview of boot media replacement - FAS8200
The boot media stores a primary and secondary set of system (boot image) files that the
system uses when it boots. Depending on your network configuration, you can perform
either a nondisruptive or disruptive replacement.
289
To Next Page
Loading...
