NetApp FAS500f - Page 702

If the management network
has DHCP…
Then…
Not configured a. Open a console session using PuTTY, a terminal server, or the
equivalent for your environment.
Check your laptop or console’s online help if
you do not know how to configure PuTTY.
b. Enter the management IP address when prompted by the
script.
6. Using System Manager on your laptop or console, configure your cluster:
a. Point your browser to the node management IP address.
The format for the address is
https://x.x.x.x.
b. Configure the system using the data you collected in the ONTAP Configuration Guide .
7. Set up your account and download Active IQ Config Advisor:
a. Log in to your existing account or create an account.
NetApp Support Registration
b. Register your system.
NetApp Product Registration
c. Download Active IQ Config Advisor.
NetApp Downloads: Config Advisor
8. Verify the health of your system by running Config Advisor.
9. After you have completed the initial configuration, go to the
ONTAP & ONTAP System Manager
Documentation Resources
page for information about configuring additional features in ONTAP.
Maintain
Add an I/O module - FAS9500
You can add an I/O module to your system by either replacing a NIC or storage adapter with a new one in a
fully-populated system, or by adding a new NIC or storage adapter into an empty chassis slot in your system.
Before you begin
• Check the
NetApp Hardware Universe to make sure that the new I/O module is compatible with your
system and version of ONTAP you’re running.
• If multiple slots are available, check the slot priorities in
NetApp Hardware Universe and use the best one
available for your I/O module.
700