NetApp FAS500f - Page 717

If your system has… Then…
No network connection a.
Press
n when prompted to restore the backup configuration.
b. Reboot the system when prompted by the system.
c. Select the Update flash from backup config (sync flash) option
from the displayed menu.
If you are prompted to continue with the update, press
y.
No network connection and is in a
MetroCluster IP configuration
a.
Press
n when prompted to restore the backup configuration.
b. Reboot the system when prompted by the system.
c. Wait for the iSCSI storage connections to connect.
You can proceed after you see the following messages:
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected
for the target iSCSI-target (type:
dr_auxiliary, address: ip-address).
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected
for the target iSCSI-target (type:
dr_partner, address: ip-address).
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected
for the target iSCSI-target (type:
dr_auxiliary, address: ip-address).
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to Connected
for the target iSCSI-target (type:
dr_partner, address: ip-address).
d. Select the Update flash from backup config (sync flash) option
from the displayed menu.
If you are prompted to continue with the update, press
y.
4. Ensure that the environmental variables are set as expected:
a. Take the node to the LOADER prompt.
b.
Check the environment variable settings with the
printenv command.
715