Restore NVE or NSE when Onboard Key Manager is enabled
1. Connect the console cable to the target node.
2.
Use the
boot_ontap command at the LOADER prompt to boot the node.
3. Check the console output:
If the console displays… Then…
The LOADER prompt
Boot the node to the boot menu: boot_ontap menu
Waiting for giveback…. a.
Enter
Ctrl-C at the prompt
b. At the message: Do you wish to halt this node rather than wait
[y/n]? , enter:
y
c.
At the LOADER prompt, enter the
boot_ontap menu command.
4.
At the Boot Menu, enter the hidden command,
recover_onboard_keymanager, and reply y at the
prompt.
5. Enter the passphrase for the onboard key manager you obtained from the customer at the beginning of this
procedure.
6. When prompted to enter the backup data, paste the backup data you captured at the beginning of this
section, when asked. Paste the output of
security key-manager backup show OR security key-
manager onboard show-backup
command.
The data is output from either security key-manager backup show or security key-
manager onboard show-backup` command.
Example of backup data:
Enter the backup data:
717
To Next Page
