Security Gateway Manual Netgate-2100
Fig. 1: Removing the Netgate 2100 Case Screws
2. Turn system upright and carefully remove the cover. Set the cover off to the side and keep it upright so the top
is not scratched. Identify where the M.2 SATA drive slot is located and remove the screw from the standoff.
Note: If the standoff turns while attempting to remove the screw, hold the standoff with a fine pair of needle-
nosed pliers.
Fig. 2: M.2 SATA Location and Screw
3. After the screw has been removed, insert the M.2 SATA drive into the slot at about a 30° angle.
© Copyright 2023 Rubicon Communications LLC 44
To Next Page
Loading...
