Netgate Netgate-2100 - Page 47

Security Gateway Manual Netgate-2100
Warning: The M.2 SATA card is keyed. Do not force it into the slot.
Fig. 3: Insert the M.2 SATA Drive at about a 30° Angle
4. Gently push down the M.2 SATA card and replace the screw into the standoff.
5. Place the cover back on and turn the Netgate 2100 over. Replace the four (4) T10 Torx case screws. Be careful
not to crossthread the screws or overtighten them.
6. Reinstall the pfSense
®
Plus software on the new M.2 SATA drive.
7. Restore the configuration backup if one is available.
See also:
For information on restoring from a previously saved configuration, see Backup and Restore.
© Copyright 2023 Rubicon Communications LLC 45