Security Gateway Manual Netgate-2100
• Click Save
Add rule to pass from this interface network to any destination:
• Click to add a new rule at the bottom of the list.
• Configure the rule as follows:
Action Pass
Interface OPTx (or the custom name)
Protocol Any
Source OPTx Net (or the custom name)
Destination Any
Description Default allow all from OTPx
• Click Save
With the rules all in place, now click Apply Changes to finish and activate the new rules.
After the configuration, the rules should look like the following figure:
Fig. 1: Example firewall rules for isolated LAN type segment
Tip: Rule separators are useful for documenting a ruleset in place.
Similar to the isolated network, it’s also possible to be much more strict with rules to only allow specific outbound
ports. When creating this type of configuration,
© Copyright 2023 Rubicon Communications LLC 66
To Next Page
Loading...
