Wall-mount the router horizontally You can mount model BR200 horizontally
to a wall with the cables either at the bottom or top of the router.
To mount model BR200 horizontally to a wall:
1.
Locate the four holes on the bottom panel of the router.
2.
Mark the four mounting holes on the wall where you want to mount the router.
The four mounting holes must be in a square at precise distances of 4 inches
(100 mm) from each other. In the following figure, each green arrow represents
100 mm.
3.
Drill holes into the wall for four anchors in which you will insert M4 x L25 mm screws.
The screws and anchors are in the router package.
4. Insert the anchors into the wall and tighten the screws with a No. 2 Phillips screwdriver.
Leave about ¼ inch (6 mm) of each screw protruded from the wall so that you can
insert the screws into the holes on the bottom of the router.
Hardware Installation Guide19Installation
Insight Managed Business Router BR200
To Next Page
Loading...
