NETGEAR BR500

Your browser might display a security message, which you can ignore. For more
information, see Log in to the local browser interface on page 16.
A login window opens.
3. Enter the router user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. If you didn’t change the password, enter password. The user name
and password are case-sensitive.
The Dashboard displays.
4.
Select ADVANCED > Firewall > Traffic Rules.
The Traffic Rules page displays.
5.
Click the Add button.
The Add Traffic Rule slide-out panel opens.
6.
In the Name field, enter a name for the traffic rule.
The name is for identification purposes.
7.
From the Protocol menu, select the protocol to which the rule must apply.
By default, the selection is ALL and the rule applies to the ICMP, UDP, and TCP
protocols.
8.
Specify the source or sources from which the traffic originates by doing the following:
a. Select a Source Zone radio button:
•
LAN. The traffic originates from the LAN. If you set up more than one LAN
subnet, select the check box for the LAN. By default, the selection is LAN1.
•
WAN. The traffic originates from the WAN.
b.
If the traffic for the rule must originate from a specific IP address, enter the IP
address. Otherwise, leave the default setting of any.
c.
If the traffic for the rule must originate from a specific port, enter the port number.
Otherwise, leave the default setting of any.
d.
If the traffic for the rule must originate from a MAC address, enter the MAC
address. Otherwise, leave the default setting of any.
User Manual66Manage the Firewall and
Security
Insight Instant VPN Router BR500