NETGEAR CM600 User Manual

Manage and Monitor
20
CM600 Cable Modem
WARNING:
To avoid the risk of corrupting the firmware, do not interrupt the
reset. For example, if you are connected to the web management
interface, do not close the browser, click a link, or load a new page.
Do not turn off the cable modem.
Use the Factory Reset Software Button
CAUTION:
This process erases all settings that you configured in the cable modem.
 To erase the settings:
1. Launch a web browser from a computer that is attached over an Ethernet cable to the
cable modem or from a computer that is connected to a WiFi router that is attached over an
Ethernet cable t
o the cable modem.
2. T
ype http://192.168.100.1.
A login window opens.
3. Enter the cable modem user name and password.
The user name is admin.
The default password is password. The user name and
password are case-sensitive.
The BASIC Home page displays.
4. Select ADV
ANCED.
The ADVANCED Home page displays the Cable Information pane.
5. Click the Factory reset button.
A confirmation message displays.
6. Click the OK button.
The configuration is reset to factory default settings. When the reset is complete, the
cable modem reboots.
This process takes about one minute.
WARNING:
To avoid the risk of corrupting the firmware, do not interrupt the
reset. For example, do not close the browser, click a link, or load a
new page. Do not turn off the cable modem.
DRAFT

NETGEAR CM600 Specifications

General

DOCSIS Standard	DOCSIS 3.0
Channel Bonding	24x8
Maximum Download Speed	960 Mbps
Ethernet Ports	1 Gigabit Ethernet port
Downstream Channels	24
Upstream Channels	8
Hardware Warranty	1-year limited hardware warranty
Compatibility	Compatible with major cable internet providers
Compatible ISPs	Xfinity, Spectrum, Cox