Chapter 4: Installation | 19
FS728TP Hardware Installation Guide
Step 2: Installing the Switch
The FS728TP can be used on a flat surface or mounted on the wall.
Installing the Switch on a Flat Surface
The switch ships with four self-adhesive rubber footpads. Stick one rubber footpad on each
of the four concave spaces on the bottom of the switch. The rubber footpads cushion the
switch against shock/vibrations.
Installing the Switch in a Rack
To install the switch in a rack, you need the 19-inch rackmount kit supplied with switch.
1. Attach the supplied mounting brackets to the side of the switch.
2. Insert the screws provided in the rackmount kit through each bracket and into the bracket
mounting holes in the switch.
3. Tighten the screws with a #1 Phillips screwdriver to secure each bracket.
4. Align the mounting holes in the brackets with the holes in the rack, and insert two pan-head
screws with nylon washers through each bracket and into the rack.
To Next Page
Loading...
Need help?
General