Chapter 1: Introduction | 7
FS728TP Hardware Installation Guide
Features
The following list identifies the key features of the FS728TP:
• 24-port Fast Ethernet Smart Switch with 24 PoE ports with 2 combo ports and 2 Gigabit
copper uplinks.
• Four 10/100/1000 Gigabit Ethernet switching ports.
• Two 1000M SFP Gigabit Ethernet switching ports.
• Full NETGEAR Smart Switch functionality.
• Full compatibility with IEEE standards:
• IEEE 802.3 CSMA/CD
• IEEE 802.3i (10BASE-T)
• IEEE 802.3u (100BASE-TX)
• IEEE 802.3x (Full-duplex flow control)
• IEEE 802.3ab (1000BASE-T)
• IEEE 802.3z (1000BASE-x)
• IEEE 802.3af (DTE power via MDI)
• Autosensing and auto-negotiating capabilities for all ports.
• Auto Uplink™ on all ports to make the right connection.
• Automatic address learning function to build the packet-forwarding information table. The
table contains up to 4K Media Access Control (MAC) addresses.
• Store-and-Forward transmission to remove bad packets from the network.
• Full-duplex IEEE 802.3x pause frame flow control.
• Active flow control to minimize packet loss and frame drops.
• Half-duplex backpressure control.
• Per port LEDs, power LED, PoE Max, and fan.
• Standard NETGEAR 7xx series chassis.
• NETGEAR Green product features.
PoE Features
The FS728TP supports IEEE 802.3af PSE features:
• Ports 1 through 24 support IEEE 802.3af, Alternative A (MDI-X). The total PoE power
budget is 192 Watts, with a maximum of 15.4 Watts per PoE port.
• PoE is enabled by default.
To Next Page
Loading...
