Customize Firewall Protection
245
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
To add an IPv4 LAN DMZ outbound rule:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Security > Firewall > LAN DMZ Rules.
The LAN DMZ Rules screen displays the IPv4 settings.
7. Under the Outbound Services table, click the Add button.
The Add LAN DMZ Outbound Service screen for IPv4 displays.
To Next Page
Loading...
