Monitor System Access and Performance
564
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
9. Click the Apply button.
Your settings are saved.
Manage the LAN IPv4 Traffic Meter
The following sections provide information about managing the LAN IPv4 traffic meter:
• Configure and Enable the Traffic Meter for a LAN IPv4 Address Account
• View Traffic Meter Statistics for a LAN Account
• Change the Traffic Meter for a LAN Account
• Remove One or More LAN Traffic Meter Accounts
Increase this month
limit by
Select this check box to temporarily increase a previously specified monthly traffic
volume limit, and enter the additional allowed volume in MB. The default setting is 0
MB.
Note: When you click the Apply button to save these settings, this field is reset to 0
MB so that the increase is applied only once.
This month limit This is a nonconfigurable field that displays the total monthly traffic volume limit that
applies to this month. This total is the sum of the monthly traffic volume and the
increased traffic volume.
Traffic Counter
Restart Traffic
Counter
Select when the traffic counter restarts:
• Restart Traffic Counter Now. Select this option and click the Apply button at
the bottom to restart the traffic counter immediately.
• Restart Traffic Counter at a Specific Time. Restart the traffic counter at a
specific time and day of the month. Complete the time fields and select the
meridiem and the day of the month from the menus.
Send e-mail report
before restarting
counter
An email report is sent immediately before the counter restarts. Ensure that emailing
of logs is enabled (see Enable and Schedule Emailing of Logs on page 573).
When Limit is reached
Block Traffic Select which action the VPN firewall performs when the traffic limit is reached:
• Block All Traffic. All incoming and outgoing Internet and email traffic is
blocked.
• Block All Traffic Except E-Mail. All incoming and outgoing Internet traffic is
blocked but incoming and outgoing email traffic is still allowed.
Send e-mail alert An email alert is sent when traffic is blocked. Ensure that emailing of logs is enabled
(see Enable and Schedule Emailing of Logs on page 573).
Setting Description
To Next Page
Loading...
