NETGEAR FVS336Gv3 - Page 563

Monitor System Access and Performance
563
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
7. If you want to configure the settings for the WAN2 interface, click the WAN2 Traffic Meter
tab.
8. Enter the settings as described in the following table.
Setting Description
Enable Traffic Meter
In the Do you want to enable Traffic Metering on WAN1? section, select a radio button:
• Yes. Traffic metering is enabled and the traffic meter records the volume of Internet traffic passing
through the WAN interface. Complete the fields on the right (see explanations later in this table).
• No. Traffic metering is disabled. This is the default setting.
Select a radio button to specify if or how the VPN firewall applies restrictions when the traffic limit is
reached:
• No Limit. No restrictions are applied when the traffic limit is reached.
• Download only. Restrictions are applied to incoming traffic when the traffic limit is reached. Complete
the Monthly Limit field.
• Both Directions. Restrictions are applied to both incoming and outgoing traffic when the traffic limit is
reached. Complete the Monthly Limit field.
Monthly Limit Enter the monthly traffic volume limit in MB. The default setting is 0 MB.