Set Up Virtual Private Networking With IPSec Connections
411
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
14. Specify the following default lifetimes in seconds to match the configuration on the VPN
firewall:
• Authentication (IKE), Default. Enter 3600 seconds.
Note: The default setting is 28800 seconds (eight hours). However, for a
Mode Config configuration, NETGEAR recommends 3600 seconds
(one hour).
• Encryption (IPSec), Default. Enter 3600 seconds.
15. Select the Dead Peer Detection (DPD) check box and configure the following DPD settings
to match the configuration on the VPN firewall:
• Check Interval. Enter 30 seconds.
• Max. number of entries. Enter 3 retries.
• Delay between entries. Leave the default delay setting of 15 seconds.
16. Click the Save button.
Your settings are saved.
The Mode Config configuration of the VPN client is now complete.
Test the Mode Config Connection
Note: In this section, the NETGEAR ProSAFE VPN Client is referred to as
the VPN client.
To Next Page
Loading...
