Set Up Virtual Private Networking With IPSec Connections
412
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
After you have set up the Mode Config configuration on both the VPN client and the VPN
firewall, test the configuration to make sure that the VPN firewall does assign an IP address
to the VPN client.
To test the Mode Config connection from the VPN client to the VPN firewall:
1. On the computer that has the VPN client installed, right-click the system tray icon and
select Open tunnel ‘Tunnel_ModeConfig’.
When the tunnel opens successfully, the Tunnel opened message displays above the
system tray and the VPN client displays a green icon in the system tray.
2. Verify that the VPN firewall issues an IP address to the VPN client.
3. In the tree list pane of the Configuration Panel screen, right-click the IPSec configuration.
In the following figure, the name of the IPSec configuration is GW_ModeConfig. (The
default name is Tunnel.) The figure shows the upper part of the IPSec pane of the VPN
client only.
This IP address displays in the VPN Client address field.
4. From the client computer, try to access a device or web address on the LAN of the VPN
firewall.
To Next Page
Loading...
