Set Up Virtual Private Networking with SSL Connections
462
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select VPN > SSL VPN > Port Forwarding.
The Port Forwarding screen displays.
7. In the List of Configured Applications for Port Forwarding table, to the right of the host
name that you want to remove, click the corresponding Delete button.
The IP address and port number are removed from the List of Configured Applications for
Port Forwarding table.
Configure the SSL VPN Client
The following sections provide information about configuring SSL VPN clients:
• SSL VPN Clients Overview
• Configure the Client IPv4 Address Range
• Add an IPv4 Route for VPN Tunnel Clients
• Configure the Client IPv6 Address Range
• Add an IPv6 Route for VPN Tunnel Clients
• Remove an IPv4 or IPv6 Client Route
SSL VPN Clients Overview
Note: The SSL VPN client does not apply if you configure port forwarding
capability for an SSL portal. The SSL VPN client applies only for VPN
tunnel capability.
The SSL VPN client on the VPN firewall assigns IP addresses to remote VPN tunnel clients.
Because the VPN tunnel connection is a point-to-point connection, you can assign IP
addresses from the local subnet to the remote VPN tunnel clients.
The following are some additional considerations for the SSL VPN client:
• To prevent the virtual (PPP) interface address of a VPN tunnel client from conflicting with
addresses on the local network, configure an IP address range that does not directly
overlap with addresses on your local network. For example, if 192.168.1.1 through
To Next Page
Loading...
