Customize Firewall Protection
262
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
IPv6 LAN WAN Inbound Rule: Restrict RTelnet from a Single WAN User to a
Single LAN User
If you want to restrict incoming reverse Telnet (RTelnet) sessions from a single IPv6 WAN
user to a single IPv6 LAN user, specify the initiating IPv6 WAN address and the receiving
IPv6 LAN address.
To restrict RTelnet traffic from a single WAN user to a single LAN user:
1. On your computer, launch an Internet browser.
2. In the address field of your browser, enter the IP address that was assigned to the VPN
firewall during the installation process.
The VPN firewall factory default IP address is 192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
3. In the Username field, type your user name and in the Password / Passcode field, type
your password.
For the default administrative account, the default user name is admin and the default
password is password.
4. If you changed the default domain or were assigned a domain, from the Domain menu,
select the domain.
If you did not change the domain or were not assigned a domain, leave the menu
selection at geardomain.
5. Click the Login button.
The Router Status screen displays.
6. Select Security > Firewall.
The Firewall submenu tabs display with the LAN WAN Rules screen in view, displaying
the IPv4 settings.
7. In the upper right, select the IPv6 radio button.
The LAN WAN Rules screen displays the IPv6 settings.
8. Under the Inbound Services table, click the Add button.
The Add LAN WAN Inbound Service screen for IPv6 displays.
To Next Page
Loading...
