Set Up Virtual Private Networking With IPSec Connections
348
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
Figure 10. Example of an IPv4 client-to-gateway IPSec VPN connection
The VPN firewall supports client connections with the NETGEAR ProSAFE VPN Client, which is
an application that you can install on a computer.
The VPN firewall is bundled with a single-user license of the NETGEAR ProSAFE VPN Client
software (VPN01L). For information about the NETGEAR ProSAFE VPN Client, including
information about multi-user licenses, visit
http://www.netgear.com/business/products/security/vpn-software.aspx.
Note: The NETGEAR ProSAFE VPN Client supports IPv4 only; a future
release of the VPN Client might support IPv6.
Setting up an IPv4 client-to-gateway connection includes two tasks:
1. On the VPN firewall, use the IPSec VPN Wizard to set up a connection to the client (see
Use the VPN Wizard to Configure the Gateway for a Client Tunnel on page 348).
2. On the computer that has the VPN ProSAFE Client installed, set up a connection to the
VPN firewall. You can use one of two methods, which are described in the following
sections:
• Use the NETGEAR ProSAFE VPN Client Wizard to Create a Secure Connection to
the VPN Firewall on page 352
• Manually Create a Secure Connection to the VPN Firewall Using the NETGEAR
ProSAFE VPN Client on page 357
Use the VPN Wizard to Configure the Gateway for a Client Tunnel
The following procedure describes how to set up thew VPN firewall for a client-to-gateway
VPN tunnel using the VPN Wizard.
Note: In this section, the NETGEAR ProSAFE VPN Client is referred to as
the VPN client.
To Next Page
Loading...
