Set Up Virtual Private Networking With IPSec Connections
407
ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3
4. Specify the settings that are described in the following table.
5. Click the Save button.
Your settings are saved.
6. In the Authentication pane, click the Advanced tab.
Setting Description
Interface From the menu, select Any.
Remote Gateway Enter the remote IP address or DNS name of the VPN firewall. For example, enter
192.168.15.175.
Preshared Key Select the Preshared Key radio button and configure the following settings:
1. Enter the pre-shared key that you already specified on the VPN firewall. For
example, enter H8!spsf3#JYK2!.
2. In the Confirm field, enter the pre-shared key again.
Encryption From the menu, select the 3DES encryption algorithm.
Authentication From the menu, select the SHA1 authentication algorithm.
Key Group From the menu, select the DH2 (1024) key group.
Note: On the VPN firewall, this key group is referred to as Diffie-Hellman Group 2
(1024 bit).
To Next Page
Loading...
