Manual Driver Installation B-1
Appendix B
Manual Driver Installation
This Appendix describes how to install your NETGEAR 10/100/1000 Mbps Gigabit Ethernet
Adapter GA311 driver without using the setup.exe but rather manually through the Windows
utilities.
Basic Installation Instructions
Use the procedure below that corresponds to the version of Windows you are using:
• Windows XP
• Windows 2000, Windows 98SE 2nd edition, Windows Me
• Windows NT 4.0
Note: The procedures below will only install the GA311 driver. If you also want the
GA311 utility, run the launch.exe program in the GA311 directory on the NETGEAR
Adapter Resource CD.
To Next Page
Loading...
