EasyManuals Logo

NETGEAR GS108GE User Manual

NETGEAR GS108GE
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Prepare to Install the Switch
Decide where you want to place the switch. Find a flat horizontal surface — such as a table,
desk or shelf. The switch comes with wall-mounting screws. Youre welcome to use the screws if
you want to hang the switch in an open space on a wall.
Make sure the selected location is:
Not in direct sunlight or near a heater or heating vent.
Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on all
sides of the switch.
Well ventilated (especially if it is in a closet).
Also, youll need one Category 5 (Cat 5) Ethernet cable with RJ-45 connectors for each device
you want to connect to the switch. Each Ethernet cable must be less than 328 feet (100 meters).
2
2
Downloaded from www.vandenborre.be

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GS108GE and is the answer not in the manual?

NETGEAR GS108GE Specifications

General IconGeneral
ModelGS108GE
CategorySwitch
Switching Capacity16 Gbps
MAC Address Table Size4K
Form FactorDesktop
Power SupplyExternal
Forwarding Rate11.9 Mpps
Switch TypeUnmanaged
Storage Temperature-20° to 70°C (-4° to 158°F)
Humidity90% maximum relative humidity, non-condensing
Operating Temperature0°C to 40°C
Standards ComplianceIEEE 802.3u
Ports8 x 10/100/1000 Mbps RJ45
Jumbo Frame SupportUp to 9KB

Related product manuals