•
Allow the product to cool before removing covers or touching internal components.
•
Operate the product only from the type of external power source indicated on the
electrical ratings label. If you are not sure of the type of power source required,
consult your service provider or local power company.
•
To avoid damaging your system, be sure that the voltage selection switch (if provided)
on the power supply is set to match the power at your location:
-
115V, 60 Hz in most of North and South America and some Far Eastern countries
such as South Korea and Taiwan
- 100V, 50 Hz in eastern Japan and 100V, 60 Hz in western Japan
-
230V, 50 Hz in most of Europe, the Middle East, and the Far East
•
Be sure that attached devices are electrically rated to operate with the power available
in your location.
•
Use only approved power cables. If you were not provided with a power cable for
your system or for any AC-powered option intended for your system, purchase a
power cable approved for your country. The power cable must be rated for the
product and for the voltage and current marked on the product electrical ratings
label. The voltage and current rating of the cable must be greater than the ratings
marked on the product.
•
To help prevent electric shock, plug the system and peripheral power cables into
properly grounded electrical outlets.
•
The peripheral power cables are equipped with three-prong plugs to help ensure
proper grounding. Do not use adapter plugs or remove the grounding prong from
a cable. If you must use an extension cable, use a three-wire cable with properly
grounded plugs.
•
Observe extension cable and power strip ratings. Make sure that the total ampere
rating of all products plugged into the extension cable or power strip does not
exceed 80 percent of the ampere ratings limit for the extension cable or power strip.
•
To help protect your system from sudden, transient increases and decreases in
electrical power, use a surge suppressor, line conditioner, or uninterruptible power
supply (UPS).
•
Position system cables and power cables carefully. Route cables so that they cannot
be stepped on or tripped over. Be sure that nothing rests on any cables.
•
Do not modify power cables or plugs. Consult a licensed electrician or your power
company for site modifications.
•
Always follow your local and national wiring rules.
User Manual13Hardware Overview of the
Switch
8-Port Gigabit Ethernet Smart Managed Plus Switch Model GS110EMX
To Next Page
Loading...
Need help?
General
Weight and Dimensions
