NETGEAR GS305EP User Manual

Factory default settings
You can return the switch to its factory settings. Use the end of a paper clip or some
other similar object to press and hold the Reset button on the front panel of the switch
for at least ten seconds. The switch resets and returns to the factory settings that are
shown in the following table.
Table 7. Factory default settings
SettingFeature
passwordSwitch password
192.168.0.239 (if the switch is not connected to a network with a DHCP server)IP address
255.255.255.0Subnet mask
EnabledDHCP mode
EnabledIGMP snooping
None configuredLAGs
Disabled. If enabled, by default, all ports are members of VLAN 1.VLANs
Enabled802.1p/DSCP-based QoS
DisabledPort-based QoS
DisabledRate limiting
DisabledBroadcast filtering
DisabledLoop detection
AutonegotiationPort speed
DisabledFlow control
DisabledPort mirroring
User Manual90Factory Default Settings and
Technical Specifications
Gigabit Ethernet Smart Managed Plus Switches Series 3XXEP and 3XXEPP

NETGEAR GS305EP Specifications

General

Model	GS305EP
Category	Switch
PoE Ports	4
PoE Budget	63W
Switching Capacity	10 Gbps
Form Factor	Desktop
Management	Unmanaged
Forwarding Rate	7.44 Mpps
MAC Address Table Size	2K
Energy Efficient Ethernet (EEE)	Yes
Power Supply	External power adapter
Operating Temperature	0° to 40° C (32° to 104° F)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Humidity	90% maximum relative humidity, non-condensing
Ports	5 Gigabit Ethernet ports
Dimensions (W x D x H)	158 x 101 x 29 mm (6.22 x 3.98 x 1.14 in)