NETGEAR GS308EPP

Chapter 4 Use VLANS for Traffic Segmentation
VLAN overview....................................................................................33
Activate the Basic Port-Based VLAN mode and assign VLANs.....35
Manage advanced port-based VLANs.............................................36
Activate the Advanced Port-Based VLAN Mode........................36
Create an advanced port-based VLAN.......................................37
Change an advanced port-based VLAN.....................................38
Delete an advanced port-based VLAN.......................................39
Manage basic 802.1Q VLANs...........................................................40
Activate the Basic 802.1Q VLAN mode.......................................40
Create a basic 802.1Q VLAN and assign ports as members....41
Assign the port mode in a basic 802.1Q VLAN configuration..43
Change a basic 802.1Q VLAN......................................................44
Delete a basic 802.1Q VLAN........................................................45
Manage advanced 802.1Q VLANs...................................................46
Activate the advanced 802.1Q VLAN mode..............................47
Create an advanced 802.1Q VLAN.............................................48
Change an advanced 802.1Q VLAN...........................................49
Specify a port PVID for an advanced 802.1Q VLAN..................50
Set an existing advanced 802.1Q VLAN as the voice VLAN and
adjust the CoS value......................................................................52
Change the OUI table for the voice VLAN..................................53
Delete an advanced 802.1Q VLAN..............................................54
Deactivate a port-based or 802.1Q VLAN mode and delete all
VLANs...................................................................................................55
Chapter 5 Manage the Switch in Your Network
Manage NETGEAR Switch Discovery Protocol...............................58
Set up static link aggregation...........................................................58
Set up a link aggregation group..................................................59
Make a link aggregation connection...........................................60
Enable a link aggregation group.................................................60
Manage multicast...............................................................................61
Manage IGMP snooping...............................................................62
Enable a VLAN for IGMP snooping..............................................62
Manage blocking of unknown multicast addresses..................63
Manage IGMPv3 IP header validation.........................................64
Set up a static router port for IGMP snooping...........................65
Change the IP address of the switch................................................66
Reenable the DHCP client of the switch..........................................67
Chapter 6 Maintain and Monitor the Switch
Manually check for new switch firmware and update the switch..69
4
Gigabit Ethernet Smart Managed Plus Switches Series 3XXEP and 3XXEPP