GS748T Software User Manual
4-8 Configuring the Switch
v2.0, April 2007
Adding and Configuring IEEE 802.1Q VLAN Groups
1. From the main Navigation Pane menu, select:
VLAN
→ VLAN Group Setting → IEEE 802.1Q VLAN; a screen appears showing a
VLAN selection window with a table that lists all of the ports with their VLAN membership.
If you have not previously created a VLAN, this window shows VLAN ID 1 (default) with all
ports set Untagged.
From the page, you can create a new VLAN, add new ports to an existing VLAN, remove
ports from an existing VLAN or, delete a VLAN.
2. Create a new VLAN Group:
From the VLAN Management pull-down window, select: Add new VLAN.
Enter the VLAN ID value in the VLAN ID dialog window that appears. Your VLAN ID must
lie in the range 2 – 4094.
Click Apply
3. Add VLAN group members as you require:
In the port table, click successively on the window below the port number to obtain your
required symbol:
• ‘T’ (tagged): this option sets egress frames with 802.1Q VLAN tags.
• ‘U’ (untagged): this option determines that frames from these ports exit the switch
untagged.
Figure 4-11
To Next Page
Loading...
