GS748T Software User Manual
Configuring the Switch 4-21
v2.0, April 2007
2. Select Enable or Disable
3. Click Apply to save your settings.
Setting Up Static Multicast Groups
You can specify specific ports and VLANs for receiving Multicast packets with specific MAC
addresses. The MAC addresses are IPv4 Multicast Addresses (RFC1112A) of the form: 01:00:5E-
XX-XX-XX. A maximum of 64 groups is supported.
To define a multicast group:
1. From the main Navigation Pane menu, select:
Switch
→ Multicast→ Static Multicast Group; the Static Multicast Groups Setting page is
displayed as shown below.
2. In the appropriate windows, enter the VLAN ID and Port to receive the Multicast packets
3. In the MAC Address window, specify the Multicast MAC Address for the packets you want
to receive.
4. Click Apply to save your settings.
To remove a multicast group:
1. In the line of the table that specifies the group, check the Delete box.
2. Click Apply to remove the group.
Figure 4-17
To Next Page
Loading...
