GS748T Software User Manual
4-14 Configuring the Switch
v2.0, April 2007
5. Click Apply to save the settings.
Jumbo Frame Support
Jumbo Frames are not an approved standard Ethernet frame size, so you must ensure that all of
your networking equipment can support these frames to prevent them from being dropped. The
GS748T switch can carry a maximum frame size of 10240 bytes.
1. From the main Navigation Pane menu, select: Switch
→ Advanced → Jumbo Frame; The
Jumbo Frame Setting page is displayed.
2. Select Enable or Disable on this page and click Apply.
Controlling Per-port Packet Throughput
The Rate Limit Setting enables you to determine the bandwidth of the selected port. There are 11
options of data rate in the range 512K bps to 1000M bps with a disable option that applies no limit
to the data rate. Ingress and egress rates are separately configurable. The Egress Rate settings is
available only with v3h1 firmware.
Figure 4-14
To Next Page
Loading...
